FREQ BANDS:

 Satellite VSAT communication is split up in to four Radio Frequency (RF) bands that commercial communication and military satellites operate within.
These different frequency bands have separate uplink (Tx) and downlink (Rx) frequencies,
require different RF components (LNB and BUC) and are suited to different applications.

 C Band

 uplink 5.925-6.425 GHz downlink 3.7-4.2 GHz The C band is primarily used for voice and data communications as well as backhauling.

Because of its weaker power it requires a larger antenna, usually above 1.8m (6ft).

However, due to the lower frequency range, it performs better under adverse weather conditions on the ground.

C Band is part of  the 5G  multi-bands spectrum.

 X Band

 uplink 7.9- 8.4 GHz downlink 7.25 – 7.75 GHz The X band is used mainly for military communications and Wideband Global SATCOM (WGS) systems.

With relatively few satellites in orbit in this band, there is a wider separation between adjacent satellites, making it ideal for Comms-on-the Move (COTM) applications.

This band is less susceptible to rain fade than the Ku Band due to the lower frequency range, resulting in a higher performance level under adverse weather conditions.

 Ku Band

 uplink 14 GHz downlink 10.9-12.75 GHz Ku (K band Under) band is used typically for consumer direct-to-home access, distance learning applications, retail and enterprise connectivity.

The antenna sizes, ranging from 0.9m -1.8m (~6ft), are much smaller than C band because the higher frequency means that higher gain can be achieved with small antenna sizes than C-band.

Networks in this band are more susceptible to rain fade, especially in tropical areas and ACM is used to prevent these outages.

Ku Band is also popular for Internet communication on business aircraft using a motorised gimble dish antenna and  Modem.
The Tail Mounted Antenna (TMA) keeps tracking a  GEO satellite during aircraft maneuvers ie: climb and banking.
INtelSat, Viasat are GEO and  using this band.
and also  LEO, Oneweb, Starlink are  using it.

 Ka Band

 uplink 26.5-40GHz downlink 18-20 GHZ The Ka band (K band Above) is primarily used for two-way consumer broadband and military networks.

Ka band dishes can be much smaller and typically range from 60cm-1.2m (2′ to 4′) in diameter.

Transmission power is much greater compared to the C, X or Ku band beams.
Due to the higher frequencies of this band, it can be more vulnerable to signal quality problems caused by rain fade, again ACM is used to help rain fade.
O3b Network satellite service uses Ka Band for its connectivity.


Ka Band is also popular for Internet communication on business aircraft using a motorised gimble dish antenna and  Modem.
The Tail Mounted Antenna (TMA) keeps tracking a  GEO satellite during aircraft maneuvers ie: climb and banking.
INmarSAT, ViaSat are satelites service providers for Ka.
Ie:  Honeywell Jetwave is a  popular BUsiness Aircraft internet  system.

 © Copyright HOneywell - Jetwave

 OTHER BANDS 

 TYPICAL DISH ANTENNA  

 SPACE-MAP: STARLINK --- ONEWEB

 STARLINK LIVE MAP:

 ALL SATELLITES: MAPPING 

 SPECTRUM CHART

 WIFI  SPECTRUM